Control over hygroscopic growth of saline aqueous aerosol using Pluronic polymer additives

The hygroscopic properties of an aerosol originating from a nebulizer solution can affect the extent of peripheral deposition within the respiratory tract, which in turn affects drug efficacy of drugs delivered to the lungs. Thus, the ability to tailor the degree and rate of hygroscopic growth of an aerosol produced by a nebulizer through modification of the formulation would serve to improve drug efficacy through targeted lung deposition. In this study, the kinetic and thermodynamic hygroscopic properties of sodium chloride aerosol mixed with commercially available Pluronic polymers, specifically F77 and F127, are reported using three complementary single aerosol analysis techniques, specifically aerosol optical tweezers, a double ring electrodynamic balance and a concentric cylinder electrodynamic balance. The F77 polymer is shown to have a predictable effect on the hygroscopic properties of the aerosol: the ability of the droplet to uptake water from the air depends on the solute weight percent of sodium chloride present in a linear dose dependant manner. Unlike the smaller F77, a non-linear relationship was observed for the larger molecular weight F127 polymer, with significant suppression of hygroscopic growth (> 50% by mass) for solution aerosol containing even only 1 wt% of the polymer and 99 wt% sodium chloride. The suppression of growth is shown to be consistent with the formation of mixed phase aerosol particles containing hydrophilic inorganic rich domains and hydrophobic polymer rich domains that sequester some of the inorganic component, with the two phases responding to changes in relative humidity independently. This independence of coupling with the gas phase is apparent in both the equilibrium state and the kinetics of water evaporation/condensation. By starting with a saline nebulizer solution with a concentration of F127 similar to 10(-2) mM, a 12% reduction in the radius of all aerosol produced at a relative humidity (RH) of 84% is possible. The difference in diameter is RH dependent, and may be much greater at higher humidities. These findings suggest that the addition of mu M concentrations of larger Pluronic polymers to nebulizer formulations may greatly reduce the size of aerosols produced. (C) 2013 Elsevier B.V. All rights reserved.